4
Before you begin the installation
•
Read the INSTRUCTIONS!
• Always use a multi-meter when verifying
vehicle wiring.
•
Before mounting the product,
verify
with the customer the desired location for
the valet switch and LED.
•
Protect the vehicle by using fender
covers.
•
Always look before drilling. Make sure
you will not cause damage to vehicle
hoses, electrical looms or physical
damage to vehicle.
Mounting System Module
Mount the system module under the
dash where it will be difficult for a
potential thief to locate the module, and
away from moving parts such as brake
pedals, etc. Route the antenna wire away
from wire looms, computer modules
and metallic objects for better range.
Mounting Siren
Mount the siren in a suitable place
under the hood, away from hot and
moving engine parts such as manifolds,
fan belts, etc. Make sure the siren cannot
be accessed from underneath the
vehicle or through the grill. Face the
siren down so that water cannot
accumulate inside the siren bell. Protect
wires running through the firewall using
either tape or split loom tubing. If a new
hole is needed, protect the wire from
chaffing by installing a proper size
grommet.
Mounting Shock Sensor
Secure the shock sensor to the steering
column, thick wire harness or a dash
brace, using a wire tie. Make sure that the
adjustment screw is accessible for later
testing and adjustment.
14-Pin Main Harness:
• RED WIRE - +12V Battery input. Connect
the red fused wire on the main harness to a
constant +12V source. This source wire
should be at least 15 amp supply.
• WHITE WIRE - Parking Light output (+)
10A relay. Connect to the vehicle’s parking
light wire. If the vehicle’s parking light circuit
exceeds 10 amps a relay is required. For
vehicle’s with independent left and right
parking light circuits, the parking light wires
must be connected using diodes to keep the
circuits separate. A relay is required for
vehicles with negative parking light circuits.
NOTE: Do not connect the WHITE wire to
the vehicle’s headlight circuit.
• BROWN WIRE - Siren wire output (+) 3A.
Connect to the siren’s red wire. Connect
the siren’s black wire to ground.
• BLUE/WHITE WIRE - Not used.
• WHITE/RED WIRE - Not used.
• ORANGE WIRE - Armed Output (-)
500mA. Connect to a relay for optional
starter defeat (See wiring diagram). The
ORANGE wire provides a ground when the
unit is armed to activate a starter disable
relay or other device (i.e. window control
module, etc.).
• BROWN/WHITE WIRE - Horn output (-)
500mA. Connect to an optional relay to
Installation Instructions
BW1900.qxd 7/1/2005 4:16 PM Page 4
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern