1Standard Features:Two 4-Button Remote TransmittersStatus indicator (LED)Valet / override switchMulti-tone siren (115dB)Dual stage impact detectorFlas
2To arm the system passively:1. Turn the ignition key off.2. Exit the vehicle and close all doors.• The LED flashes rapidly indicatingthat the system
3LED INDICATIONSOn Solid = Valet ModeOn Solid when not in valet = Open ZoneSlow Flash = System ArmedRapid Flash when disarmed = PassiveArmingRapid Fla
4Before you begin the installation•Read the INSTRUCTIONS!• Always use a multi-meter verify wiring.•Before mounting the product,verifywith the customer
5shows ground when the door is open.• VIOLET WIRE - Positive door trigger (+).Connect to the door switch circuit wire thatshows +12V when the door is
6Entering ProgrammingTo enter System Programming:1. Turn on ignition.2. Within 5 seconds, press valet switch 5times.• The siren will chirp, to indicat
7locations. (Example: If only one transmitter isused, repeat step 3 two times to remove anypreviously programmed transmitters.)Two Car OperationTwo ca
8WIRING DIAGRAM© 2009 64-2450 6/09 Rev. 286308787a85+12VTO WIRE IN VEHICLE (-) OUTPUTFROM ALARM86308787a85(-) OUTPUTFROM ALARM+12VTO WIRE IN VEHICLE
Kommentare zu diesen Handbüchern